Sand down the curves until they rock smoothly on the floor.Ĭut the backboard piece so that it fits perfectly in the space between the two armrests (you should need to trim off the thickness of the armrest piece). Use the extra wood to make armrests and support for the backboard (step 5). use the crossing lines in the blueprint to draw the rest of your mark and cut. The curve on the bottom is part of a circle 2.5m in diameter. Now trace a circle along the edge of your string while it pivots around the anchor point (see picture). Use a 125cm stick or string, measure 125cm directly above the center of the bottom and anchor the stick/string (I used a long strip of wood and anchored it with a screw to some more wood). Armrest: For the armrest just measure 5cm from each of the bottom corners and draw a line from there to the top corners, then cut.

remember that each wing is leaning in a different direction so cut the bottoms accordingly.

Now cut the bottoms at a 14 degree angle, If you don't have the tools to do this accurately, draw a line 0.5cm from the bottom and cut between that line and the opposite corner as accurately as you can, then correct by sanding. Wings: The two wing are identical so they fit together, all you need to do is draw a 32 cm line at 20cm from each side and connect the ends, then cut through that line.

Baby crib diy 24 boards